Topcon TRL-35, Operator'S Manual

Page: 27 / 48

Configuring the TRL-35
P/N 7010-0815
2-11
11. On the
Serial Interface
screen, select a baud rate for the modem’s
serial port. The same rate must be used for both the receiver and
the transmitter. The recommended baud rate is
38400
.
12. Select the RTS/CTS (Ready to Send/Command to Send) as
ON
.
13. Click
Apply
.
14. Click on
File Disconnect
.
15. To close Modem-TPS, choose
File Exit
.
16. Launch PC-CDU with the TRL-35 connected to a receiver and
setup the receiver to run as an RTK Base station.
As a Repeater in Modem-TPS in
Simplex Protocol
The TRL-35 provides high powered TX communications from the
base station to the rover. To configure the UHF radio modems, have
the following ready:
• PC running Windows 98, 2000, NT, or XP
• Modem-TPS 2.2p0 or later
• TRL-35 Programming cable, Topcon P/N 14-008107-01LF
• TRL-35 Power cable, Topcon P/N 14-008110-01
1. Connect the computer and TRL-35 using the TRL-35
programming cable.
2. Connect the power cable to the TRL-35 and confirm the power
LED is on.
3. Open Modem-TPS and on the connection dialog box, then click
Cancel
.
NOTE
To comply with RF exposure requirements,
maintain at least 25cm between the user and the
radio modem.
NOTE
Before connecting power to the TRL-35 confirm
the modem antenna is attached.