Topcon Pocket-3D, Reference Manual, Page: 78 / 316

Setup Menu
Pocket-3D Reference Guide
2-32
• Units – select the unit of measure.
NOTE:
These units do not relate to job units.
• Vert. dist. from prism center to pole tip – enter the measured
distances for the prism and the offset.
– Height of prism: enter the vertical height of the prism.
– Prism offset: enter the prism offset.
Figure 2-44. Range Pole Parameters
Sample Configuration 4: Prism and
Total Station
Before beginning to track a prism, there must be an equipment
configuration file defined in Pocket-3D. The following procedure is
an example of a prism configuration for a GPT-8000 series total
station.
1. Press
Setup

Equipment
to create or select an equipment
configuration file. The following steps describe creating a file.
2. On the
Machine files
dialog box, press
New
to create (or
Edit
to
change) a total station configuration (Figure 2-45 on page 2-33).
3. On the
Configuration name
dialog box, set the following
equipment parameters, and press
Next
(Figure 2-45 on

page 2-33).
• Configuration name – enter a name for the configuration file.
• Machine type – select Range pole from the drop-down list.
• Sensor – select prism from the drop-down list.