15
5
Electrical Installation
Figure 17: Electrical Installation
Only the components shown in black are included in this kit.
1.
Plug the 3-pin tower on C70 to the 3-pin shroud on the valve extension cable (C11). Route
C70 to the rear of the sprayer. Use cable ties to secure in place.
2.
Connect the 2-pin connectors on C70 to the 3
rd
station expansion block. The connector
labeled
Roll CW
goes on the side of the valve block with the hydraulic hoses.
Figure 18: JD Roll Connector
3.
Connect the position sensor (E06) to the 8-way coupler. Connect the active roll cylinder
(H75) to the 8-way coupler (E11) using cable C04 and a 2-way coupler (E12).
4-pin Roll
Connector
Summary of Contents for NORAC UC4.5
