Topcon mmGPS 3D Paver, Reference Manual, Page: 58 / 288

Setting up the Jobsite and Pocket-3D
mmGPS 3D Paver Reference Manual
2-24
Localizing with Pocket-3D
After setting up the Base Station, localize the jobsite coordinates with
GPS+ coordinates.
1. Ensure the control point file for the jobsite is selected (
Data
Control
) and select the equipment configuration for the current
setup (
Setup Equipment
) (Figure 2-21).
2. Tap
Data Control Control points
. Select the point to edit
and press
Edit
.
3. Check the local coordinates and press the
GPS
tab.
Figure 2-21. Select Control Point to Localize
4. Enable “Use horizontal” and “Use Vertical” and press
Measure
.
Press
Ok
to save the measurement (Figure 2-22).
Figure 2-22. Measure Control Point
1 2 3
4a 4b