Topcon mmGPS 3D Paver, Reference Manual

Page: 43 / 288

Setting Up the Base Station
P/N 7010-0781
2-9
Figure 2-5. Measure Base Station Antenna Height
Base Station Initialization
Before initializing the Base Station, check the Units used in the
current jobsite (Setup Units) and that the correct Control Point file
is selected (Data Control). Figure 2-6 on page 2-10 shows the
procedure listed below.
1. Connect the controller and receiver. Tap
Setup Base station
.
2. Select the control point over which the Base Station is installed
and the connection between controller and receiver. Press
Next
.
3. Enter antenna type and height information. Press
Ok
.
4. Enter radio type and communication information. If using a
Pacific Crest PDL UHF radio, press
Configure
to select channel
information and press
Set
. Press
Next
.
5. Press
Finish
to initialize the GPS receiver and start the Base.
Vertical Height
to ARP
Station Marker
Slant Height
to SHMM
Vertical Height
to ARP
Slant Height
to Edge of
Antenna
Station Marker
PG-A1
HiPer Lite+