Topcon mmGPS 3D Paver, Reference Manual, Page: 35 / 288

P/N 7010-0781
Chapter 2
2-1
Setting up the Jobsite
and Pocket-3D
Pocket-3D field software, which is required for some mmGPS
operations, runs on a portable hand-held controller and uses files
common with other equipment on the jobsite. Using Pocket-3D
allows multiple users to work at the same time.
Hand-held Controller and
Pocket-3D
Pocket-3D is grade and staking control software for hand-held
controllers. At the jobsite, Pocket-3D provides a way to make quick
changes and updates to files, double-check control points, initialize
the GPS base, and many other useful functions.
3DMC and Pocket-3D save files in the same format, which makes it
easier for surveyors, machine operators, and grade checkers to share
files and to update software.
Before performing any Pocket-3D configuration or application
function, check the units used at the job. Units are the method of
measurement used for measuring various data. To check, change, or
apply units to the project, tap
Setup Units
(Figure 2-1 on page 2-2).
TIP
Refer to the
Pocket-3D User’s Manual
and
Pocket-
3D Reference Manual
for further details.