Topcon mmGPS 3D Paver, Reference Manual, Page: 123 / 288

Control Menu
P/N 7010-0781
3-53
Figure 3-52. Polyline Alignment Options
Begin paving. As needed, repeat step 4 on page 3-51 to steer to
another polyline.
PZS-MC Receiver
If needed, you can use 3DMC to temporarily change the settings of
the PZS-MC sensor. The original settings (from the machine
configuration file) are restored after turning off the 9168 control box.
1. At the control box, press
Topcon Logo Control PZS-MC
receiver
and select the following receiver parameters
(Figure 3-53 on page 3-54):
• Receiver port – select the port used for GPS communication
at the MC-2.5 Receiver Box; usually Serial Port C.
• Receiver sensitivity – select the sensitivity level for detecting
the transmitter, usually Auto. Select a different setting when
working at very short or very long distances, or during
inclement weather that can affect laser detection.
• Transmitter selection – select the channel to scan for mmGPS
connection. The “All” selection allows the sensor to
independently select the transmitter with the closest
proximity to the receiver. If the PZL is not being used in the
current setup, it should be deactivated within 3DMC. If
setting up only one transmitter, but the job has been