Topcon KR-1W, Instruction Manual

Page: 58 / 188

56
INDIVIDUAL OPERATIONS
PRINTING MEASUREMENT VALUES
This instrument is equipped with a built-in printer.
1
Make sure the MEASUREMENT screen is on.
2
Tap the DATA OUT button of the control panel.
DATA OUT button lights, and measurement values on the control panel screen are
printed out.
The light of DATA OUT button is turned off.
Finish
Even after the printing operation is complete and the results displayed on the
screen is deleted, the results are stored within the instrument. So you can repeat
printing out the data by tapping the DATA OUT button until a new measure-
ment is started. The data is cleared at the start of new measurement.
1. The "ERROR" mark is not printed. Also, printing is not done if there are no mea-
surement values.
2. When red lines appear on both sides of the printer paper, replace it with a new
one earlier. For details about the replacement of printer paper, see "SETTING
THE PRINTER PAPER" on page 29. Additionally, a 58mm wide printer paper
(example: TF50KS-E2C (Nippon Paper) is recommended.
MEMO
• To avoid paper jam in the internal printer, do not feed the paper into
the printer if it is partly cut/torn or wrinkled.
• To avoid discoloration of the printing paper (particularly the recording
area) during storage, use a polypropylene holder; avoid a container
made of plasticizer (PVC, etc.).
• To avoid discoloration of the printing paper (particularly the recording
area) after pasting, use water-soluble glue.
• Since the printer paper is thermosensitive, it is not suitable for long
periods of storage. If necessary to keep records for long periods, pre-
pare separate copies.