Topcon KR-1W, Instruction Manual

Page: 135 / 188

133
FUNCTION SETTING USING SETTINGS
SETTING THE OPTOTYPE OF LANDOLT'S RING SIMULATION 2 (MIDDLE)
The optotype of Landolt's Ring Simulation 2 (Middle) is set. Before shipment, the default set-
ting is "40 (20/40)."
1
Tap the Set Condition button of the set item display "Optotype of Landolt's Ring Simula-
tion 2 (Middle)" of "DISPLAY."
2
Enter the number by the ten-key display of the Setting Change button .
3
Setting is done by tapping the OK button .
* Landolt's Ring Simulation can be set between 10 and 200 (20/10 - 20/200) with 10 steps.
SETTING THE OPTOTYPE OF LANDOLT'S RING SIMULATION 3 (LOWER)
The optotype of Landolt's Ring Simulation 3 (Lower) is set. Before shipment, the default set-
ting is "20 (20/20)."
1
Tap the Set Condition button of the set item display "Optotype of Landolt's Ring Simula-
tion 3 (Lower)" of "DISPLAY."
2
Enter the number by the ten-key display of the Setting Change button .
3
Setting is done by tapping the OK button .
* Landolt's Ring Simulation can be set between 10 and 200 (20/10 - 20/200) with 20/10
steps.
SETTING THE DIRECTION OF LANDOLT'S RING (LANDOLT DIRECTION)
The direction of Landolt's ring may be set. Before shipment, the default setting is "Right."
1
Tap the Set Condition button n of the set item display "TopoMap Kerato Axis" of "DIS-
PLAY."
2
Tap and select "Up," "Down" or "Right" or "Left" of the Setting Change button .
3
Setting is complete.
SETTING THE NORMALIZATION OF BRIGHTNESS OF LANDOLT'S RING SIMULATION
(NORMALIZE DESTINY OF SIMULATIONS)
Normalization of the brightness of the Landolt Ring Simulation can be set to ON or OFF.
Before shipment, the default setting is OFF.
1
Tap the Set Condition button of the set item display "Normalize Destiny of Simulations"
of "DISPLAY."
2
Tap the Setting Change button and select "ON" or "OFF."
3
Setting is complete.