Topcon HiPer Plus, Operator'S Manual, Page: 70 / 184

Configuration
Topcon HiPer+ Operator’s Manual
2-30
Radio Configuration
The internal radio in your HiPer+ and the base radio can be
configured differently depending on your needs and working
conditions. The software program required to configure the radio
modem differs depending on your receiver configuration, and
allows you to:
• access the internal modem
• configure the modem
• check or change the modem configuration
The following sections provide basic radio configuration
information for UHF and GSM radio modems.
NOTICE
Your receiver may be configured without a
radio modem. If this is the case, please skip to
“Collecting Almanacs” on page 2-49.
Configuring a UHF Radio Modem
To access your PDL UHF radio modem, you create a daisy
chain between the HiPer+ serial port (A or D) and the radio
modem (Port C) using PC-CDU. You then activate the PDL
configuration program on your PC and proceed with the
radio configuration.
1. Connect your receiver and computer. See “Connecting
the HiPer+ and a Computer” on page 2-5 for this
procedure.
AND
Use a 38400 baud rate.