Topcon HiPer Ga, Operator'S Manual

Page: 69 / 162

Configuring the Receiver
P/N 7010-0816
3-13
• GPS/GLO at one time – enable
• Antenna position – enter Lat, Lon, and Alt values using one
of the following methods:
– If known, type in the values.
– Enable Averaged, and enter the Averaged Span in
seconds, and then click Apply . Click Tools

Reset
receiver, and wait until the specified interval (span)
completes. Examine the Base coordinates on the Base
tab; they should correspond to the coordinates obtained
from the average. Click
Refresh if the coordinates are
zeros.
– Click Get from receiver .
Figure 3-10. Base Configuration
10. For the Rover receiver, click the Rover tab and set the following
parameters, then click Apply (Figure 3-11 on page 3-14).
• Positioning Mode – For post-processed surveys, select
Standalone; for RTK surveys, select RTK float or RTK fixed.
NOTICE
The reference geodetic coordinates specified on this
tab relate to the antenna L1 phase center.