Topcon FC-6000, Operator'S Manual

Page: 9 / 62

Chapter 1 Getting Started
5
it underneath the two battery catches. Rotate the front edge
down until it is in position.
CAUTION : Do not insert the battery pack straight down.
Damage to the unit could occur.
4. Replace the door and press down on it until the latch pops into
the locked position.
5. Attach the appropriate plug for your country into the AC wall
charger and plug it into a wall socket. Plug the other end into
the DC power jack on the FC-6000.
Note: Use the AC wall charger that came with the FC‑6000 or
another approved charger from Topcon.
6. Charge the battery pack at room temperature (68°F or 20°C) for
6 hours (for the first charge). While the battery pack is charging,
the red LED blinks. When it is fully charged and external power
is applied, the red LED is solid.
Note: The FC‑6000 will not recognize an internal battery until
the FC‑6000 is being charged for the first time.
Perform Set Up
The first time the FC-6000 is powered on, Windows setup options
are shown. Follow the prompts to set up your unit as desired.
Attach the Hand Strap and Stylus Tether
A hand strap, fine tip capacitive stylus, and tether are included with
the FC-6000.
!
Black Tab