Heating Blanket P101
5
Heating Blanket P101
ENGLISH
6
Using the heating blanket
•
The heating blanket is equipped with a control unit with 4 positions:
– 3 - maximum temperature;
– 2 - medium temperature;
– 1 - minimum temperature;
– 0 - off
•
Check that the control unit switch (A) is in position ‘0’ (lowest) before
connecting it to the mains socket.
•
The heating blanket plug (C) and mains plug are fixed to the
control unit.
•
Connect the heating blanket plug (C) to the heating blanket
connector (D).
•
Connect the mains plug to the mains socket (230V AC/50Hz).
•
Place the blanket on that part of your body you wish to heat and select the desired temperature.
•
For rapid heating, select level 3, after a few minutes the heating blanket will already be pleasantly warm.
•
After use, disconnect the blanket from the mains socket.
7
Technical data
8
Cleaning
•
Machine washing of the blanket is possible; however, hand wiping will prolong the life of the blanket.
•
To machine wash, remove the control unit and place the blanket in a
net bag
and seal it.
•
Use a small amount of detergent and set the washing machine to a
"Delicate Wash"
with a maximum
temperature of
40°C
. When washed, remove the blanket from the net bag and drape it over a clothes line to dry.
•
Do not use clothes pegs to secure it.
•
Allow the blanket to dry naturally.
WARNING
The mains socket must be close and easy accessible.
Dimensions (W/H/D)
Weight
Rated voltage
Power consumption
Material
70 cm x 150 cm
870 g
Input: AC 230 V / 50 Hz
60 W
100% polyester
WARNING
•
Never use abrasive cleaners, brushes, gasoline, kerosene, glass polish or paint thinner to clean.
•
Do not wring out the blanket
•
Do not dry using a tumble dryer
•
Do not iron the blanket
•
Do not dry clean.
•
Don't connect the blanket to power supply to dry it.
•
Don't dry it in the sun or iron it, which will cause safety problems because of the aging of the insulating layer.
•
Do not use an appliance such as a hair dryer to dry it
0
B
A
3
2
1
0
C
D
40C
HL_Heating Blanket P101 D106.book Page 5 Monday, July 11, 2011 5:14 PM