www.topaz-usa.com
• 925 Waverly Ave • Holtsville, NY 11742 • 800-666-2852 • Fax: 631-758-8026
Items:
ES/LED/RW/B and ES/LED/GW/B
LED EXIT
INSTALLATION INSTRUCTIONS
IMPORTANT
SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Review instruction sheet before beginning installation.
2. All electrical connections must be in accordance with local codes, ordinances, and the National
Electric code.
3. Disconnect power at fuse or circuit breaker before installing or servicing.
4. Not for outdoor use.
5. Do not mount in hazardous locations, or near gas or electric heaters.
6. Do not let power cords touch sharp or hot surface.
7. Equipment should be mounted in locations and at heights where it will not be subjected to
tampering by unauthorized personnel.
8. The use of accessory equipment not recommend by the manufacturer may cause an unsafe
condition.
9. Do not use this equipment for other than intended use.
10.All servicing should be performed by a qualified electrician only.
11. Allow battery to charge for 24 hours before first use.
use Flexible conduit only
SAVE THESE INSTRUCTIONS
MAINTENANCE
Equipment must be tested regularly in accordance w
ith local codes. Replace the batteries as needed according to ambient
conditions. No other maintenance required.
OPERATION
Depress test button. The LED heads will turn on and the LED indicator will turn o Release test button, LED indicator will
turn on and LED heads will turn
TROUBLE SHOOTING GUIDE
If LED heads or LED indicator do not illuminate, check the
1. Check AC supply - verify that unit has 24 hours AC supply.
2. Wiring is shorted or battery is not connected.
3. Battery discharge. Permit unit to charge r 24 hours then re-test.
4. If above trouble shooting does not solve the issue, contact manufacturer r assistance.
1 of 2
Read and review safety instructions and diagrams before starting installation.
• All electrical connections must be in accordance with local codes, ordinances, and the
National Electric code. Installation should be performed by a qualified electrician only
•
Disconnect power at fuse or circuit breaker before installing or servicing.
• Not for outdoor use.
• Do not mount in hazardous locations, or near gas or electric heaters.
• Do not let power cords touch hot surface.
• Equipment should be mounted in locations and at heights where it will not be subjected
to tampering by unauthorized personnel.
• The use of accessory equipment not recommend by the manufacturer may cause unsafe
operational condition.
• Do not use this equipment for other than intended use.
• After installation is complete, permit battery to charge 24 hours before full duration test.
MAINTENANCE
None required. Equipment must be tested regularly in accor-
dance with local codes. Replace batteries as needed
OPERATION
Press the test button. The LED heads will turn on and the LED
TROUBLE SHOOTING GUIDE: If LED indicator does not illuminate, check the following;
1.
Check AC supply - verify that unit has 24 hours AC supply.
2.
Unit is shorted or battery is not connected.
3.
Battery discharged. Permit unit to charge for 24 hours, then re-test.
4.
If above trouble shooting hints do not solve the issue, contact factory for assistance.
OPENING EXIT PANEL
Use flat blade screwdriver to open. Insert screwdriver into
