ToolPRO TPPW26, Instruction Manual, Page: 19 / 24

18 19
ENGINE OIL
Used oil is a hazardous waste product and must be
disposed of properly. Do not discard with household
waste. Check with your local authorities, service centre,
or dealer for safe disposal/recycling facilities.
Draining Oil
1. With engine off but still warm, disconnect the spark
plug wire and keep it away from the spark plug.
2. Remove the oil dipstick.
3. Remove the oil drain bolt (Pic. 21).
4. Drain the oil into an approved container.
5. After the oil has drained, install and tighten the oil
drain bolt.
To Add Engine Oil (not included)
Always use fresh oil as specified on page 8. An SAE30 or
SAE15W-40 is recommended.
1. Make sure pressure washer is level.
2. Clean the oil dipstick area of any dirt and debris.
3. Remove oil dipstick (Pic. 22) and wipe with a clean
cloth.
4. Replace the oil dipstick, DO NOT TURN OR
TIGHTEN.
5. Remove the dipstick and check the oil level. Correct
oil level is at the top of the full indicator on the
dipstick, Pic. 22.
6. Add oil, via the oil fill (Pic. 21). Add about 100ml at a
time and check before adding more oil.
7. Oil level will take about 1 minute to drain down and
settle.
8. Check oil level using the oil dipstick.
9. Replace the oil dipstick, DO NOT TURN OR
TIGHTEN.
10. Remove the dipstick and check the oil level. Correct
oil level is at the top of the full indicator on the
dipstick (Pic. 22).
11. Repeat steps 6 to 10 until correct oil level is achieved.
OIL PLUG
& OIL FILL
SUMP PLUG
& OIL DRAIN
PIC. 21
PIC. 22