16
17
CLEANING
NEVER use this pressure washer to clean itself. Damage
caused by cleaning the pressure washer with its own
gun will not be covered under warranty. Ensure pressure
washer is cool before cleaning, about 1 hour after use.
• Wipe down all surfaces with a soft clean cloth.
• Rinse all nozzles in a bucket of clean water.
• Place in holder to dry.
• Ensure fuel tap is off.
• Ensure engine switch is off.
• Ensure high pressure hose is left wound up and not
kinked.
• Store in a suitable area away from children or infirm
persons.
• Store in a suitable area which will not freeze.
STORING
If the pressure washer is not to be used or is to be stored
for more than one month the following storage procedure
should be carried out.
1. Drain all the fuel from the fuel tank and the carburettor,
ensure that all the fuel has been drained.
2. Remove the spark plug and pour approximately one
tablespoon full of clean engine oil into the spark plug
hole.
3. With the ignition turned OFF gently pull on the recoil
starter cord several times.
4. Re-fit the spark plug and continue to pull the recoil
starter cord until the piston is on the compression
stroke (when resistance is felt) then stop pulling.
5. Store the pressure washer in a dry well ventilated
place under a cover to prevent any dust or debris
from accumulating on the pressure washer.
When storing for less than 4 weeks please follow these
points to ensure no damage will occur to the pump or
motor. Any damage caused will not be covered under
warranty.
Start motor and run for no more than 30 seconds. This
cleans the pump of excess water.
• Ensure the inlet water hose is not connected
• Ensure the high pressure hose is not connected to the
pump
• Turn fuel tap on
• Turn choke lever to on (start)
• Turn engine switch to ‘on’
• Pull recoil
• Turn choke to off (run)
• Allow motor to run no more than
30 seconds
• Turn fuel tap off
• Turn engine switch off
• Drain fuel from tank and carburettor
• Clean as per “cleaning”