14
15
STARTING YOUR PRESSURE WASHER
1. Check oil level.
2. Check and fill fuel.
3. Connect garden hose to cold water source. Do not
turn on!
4. Connect garden hose to garden connection on pump.
5. Select nozzle, see page 13.
6. If using detergent place tube and filter into detergent
bottle, see page 14.
7. Turn choke to start by sliding the choke lever to the
LEFT, Pic 12.
8. Turn the fuel to run by rotating the fuel tap lever to
the right, Pic 13.
9. Turn switch to “I”, refer Pic.14.
10. Pull the recoil starter slowly until engaged, then pull
briskly. This step may need to be repeated until
pressure washer engine starts, this can take up to 12
pulls when cold, Pic 15.
Warning: Never pull the recoil once the engine has
started. Any damage caused will not be covered under
warranty.
11. Once started turn choke to off (run), slide to RIGHT.
12. Turn cold water source on.
13. Release safety lock on trigger, lift lever up, see page 11.
14. Squeeze trigger on wand. Hold down until all air
is purged and a steady stream of water is passing
through, Pic 16.
15. Release trigger to stop water flow.
WHEN FINISHED WITH DETERGENT
When finished with detergent, release trigger on wand.
Remove tube and filter from detergent bottle. Place tube
and filter around handle. Do not place on the ground as
this will suck dirt into pump. Any damage caused will not
be covered under warranty.
Change nozzle, see page 13.
Squeeze trigger and continue cleaning with clean cold
water.
STOPPING YOUR PRESSURE WASHER
To stop your pressure washer;
1. Turn cold water supply off.
2. Squeeze gun trigger to release some water and
pressure.
3. Turn fuel tap off.
4. Push engine switch off “0”.
5. Once engine has stopped, squeeze gun trigger to
release water and pressure.
6. Disconnect the garden hose from pressure pump and
garden tap.
7. Allow pressure washer to cool about 1 hour before
wiping down and store appropriately.
STARTING
HANDLE
PIC. 12
PIC. 13
PIC. 14
PIC. 15
PIC. 16