ReChargX
™
RX350
8am - 5pm ET Mon - Fri
© 1995-2016 ReChargX, EmptyX, TonerRefillKits, TonerRefillKits.com, the TonerRefillKits logo, the
V2.00 - 2016.05.09
800.527.3712 or 352.343.7533
ReChargX and EmptyX logos are trademarks owned by TonerRefillkits.com, LLC. All rights reserved.
Page 13 of 15
Step 15: Install the actuator gear on the
toner cartridge
The position of the gear must be placed properly in
order for the toner cartridge to reset the toner “low” or
“out” message.
Use your fingers to turn the actuator gear (B) in a
clockwise motion (2 - 3 times) so the middle opening
(attached to the post) appears as a “D” when facing
toward you (Figure 15).
Step 16: Install the drive gear
With the actuator gear in place, we will now install the
drive gear (A) into the gear train (Figure 16).
Step 17: Install the reset gear
With the drive gear in place, we will now install the
reset gear (C) (included in the ReChargX™ RX350
refill kit) over the post that is protruding from the toner
hopper plug (Figure 15).
Figure 15:
Installing the actuator gear
B
Figure 16:
Installing the drive gear
C
C
Figure 17:
Installing the reset gear
A
B
C
