Assembly Instructions for the
TTT 2200 and the TTT 2600 Commercial Tumbler Systems
Parts List
Steel Frame with coupler and bushing attached
4 Steel Legs
4 Rubber caps for legs (or optional wheels)
Motor with power cord with Motor shaft alignment brackets and motor
bolt (attached)
2 Mesh nets
½
”and 3/8” meshnet
1 Funnel flow bag
2 Aluminum drums
Aluminum axle
Dust Cover (with screws)
Kief Net
Tools Needed:
Phillips head screw driver
Adjustable wrench or vice grips
Allen wrenches for leg and motor
Assembly
Note: A video of assembly is also available on YouTube at https://youtu.be/s9ghOZqySNk.
Frame Assembly
Put the frame top upside down on the floor with leg connectors up. Insert leg in each connector. Tighten Allen
Screws which are embedded on the frame. Turn the frame right side up. The Trimmer frame will be very
stable.
Attach Motor to frame
Unscrew the long motor bolt and Motor Shaft Alignment brackets from the motor. Insert motor shaft through
large hole next to small hole on outside of frame on opposite side of frame of bearings. Insert motor bolt
through small hole in frame and and thread into motor. This motor bolt (allen head) is inserted from the inside
of the frame through to the motor. Hand tighten only. (this is an alignment bolt only). Next place the brackets
over the inside of frame and screw them onto the motor using the four screws provided. These hold the motor
in place and assure perfect alignment of motor shaft. Use phillips head screw driver and tighten these small
bracket screws. (do not over tighten)
