tomado TVC3001R, Instruction Manual

Page: 17 / 80

Check that the voltage stated on the information plate matches the voltage used in your region.
SWITCHING ON THE VACUUM CLEANER
1. Place the vacuum cleaner on a sturdy and flat surface.
2. Carefully pull the cord out of the vacuum cleaner and insert the plug in a power socket - fig. 5 . Do not pull the cord any
further than the red mark.
3. Adjust the telescopic tube to the required length.
4. Switch on the vacuum cleaner by pressing the on/off button with your foot - fig. 6 .
5. Depending on the surface to be cleaned, you can adjust the brushes in the floor nozzle -
fig. 6
.
When cleaning hard floors, you must make sure the brushes are extended.
When cleaning floor coverings or floor cloths, the brushes must be retracted.
6. Depending on the surface to be cleaned, you can adjust the suction power. Slide the suction power controller to the left
or to the right between the min and max indications - fig. 7 .
Minimum suction power: delicate materials, curtains
Medium suction power: furniture, rugs and mattresses
Maximum suction power: tiles, wooden or other hard floors
7. When it is difficult to move the floor nozzle over the floor, you can adjust the suction power with the min - max
suction power controller or with the extra suction power controller on the handle of the hose - fig. 8 .
SWITCHING OFF THE VACUUM CLEANER
1. Switch off the vacuum cleaner by pressing the on/off button with your foot.
2. Remove the plug from the socket, hold the plug and allow the cord to wind automatically by pressing the button
for automatic rewinding with your foot. Guide the cord with your hand to prevent possible damage. The cord
is automatically wound up in the vacuum cleaner.
STORAGE
The vacuum cleaner can be stored in two ways. Standing on its rear side - parking position - or its bottom side, so that the
appliance takes up less space - fig. 9 .
• Rewind the cord by pressing the button for automatic cord rewinding with your foot.
• Slide the button on the top side of the tube upwards and push the top part of the tube downwards to shorten the tube.
When you let go of the sliding button, the tube will snap tight.
• Slide the floor nozzle in the holder on the bottom side of the vacuum cleaner - parking position - or place the vacuum
cleaner upright and slide the floor nozzle in the holder on the bottom side of the vacuum cleaner.
USE
EN - 17
ACCESSORIES
For the benefit of the different cleaning objectives, attach the accessories to the tube or handle of the hose by sliding them
firmly on the tube or handle - fig. 2B .
13. Accessory holder: the accessory holder can be snapped on the telescopic tube - fig. 3B . The accessories can be attached
to the holder, so you always have them at your disposal when vacuum cleaning.
17.
Round brush nozzle: for cleaning hard furniture surfaces, corners of ceilings or blinds.
18. Crack nozzle: for cleaning skirting boards, corners and small areas that the brush nozzle cannot reach.