Toledo ZT-1, User Manual, Page: 15 / 36

ZT-1 User’s Manual – Installation
DOC #18172 Page 15
Illustration A - Sensor Cable Termination
1) Strip the sensor cable as shown in Figure 5 below. Be sure not to nick any of the
signal conductors or cut the braid shield.
Figure 5: Strain Gage Sensor Cable Stripping
2) Strip approximately ¼" of insulation from each of the four signal conductors.
Note: If your sensor cable is not double shielded with both foil and a braid, electrical
noise may affect your output readings.