Toledo ZT-1, User Manual, Page: 13 / 36

ZT-1 User’s Manual – Installation
DOC #18172 Page 13
Strain Gage Sensor Connection
Refer to Figure 4 for the procedures below:
Connection:
1) Prepare the sensor cable for termination as described in Illustration A on page 15.
2)
Remove the Phoenix plug from its socket on the top of the unit and wire the sensor
cable as described in Illustration B on page 16.
For specific load cell wire color code, refer to Load Cell
Specifications. Color Code wire designation may be different
than shown in Figure 4 & 6.
3) The Phoenix plug can then be inserted back into its socket.
Configuration:
1) Set the V / C dip switch to “V” position for voltage sensor. Strain Gage sensor outputs
voltage signal.
2) Set the Lg / Sm dip switch to “Sm” position for small signal. Strain Gage sensor
outputs un-amplified signal (small signal).
3) Set FIL dip switch to “No filter” position. Apply this filter only when electrical noise
becomes a problem at the ZT-1 analog outputs.