Quantium 510 Installation Manual
Introduction
Document Ref 942583-001 Rev 8
Page 1-3
1.3
Authorised Technicians
Only qualified technicians familiar with the contents of this manual should carry out the
procedures contained herein.
WARNING: ANY ATTEMPTS TO CARRY OUT THE PROCEDURES OF THIS
MANUAL, BY UNQUALIFIED OR UNAUTHORISED PERSONS, MAY
RESULT IN SERIOUS INJURY OR LOSS OF LIFE.
NOTE: - THIS MANUAL IS NOT INTENDED TO REPLACE THE SERVICES
OF A FULLY QUALIFIED TECHNICIAN.
1.4
Contact Information
For information relating to the contents of this manual please contact: -
Technical Author
Tokheim UK Ltd.
Dundee, Scotland
[email protected]
1.5
Health & Safety
1.5.1
SAFETY CHECKLIST
•
It is obligatory that this checklist be fully complied with during all work at the
petrol station, particularly construction or repair work.
•
It is the duty of the contractor to ensure that all workers employed by him obey
each and all of the relevant laws, directives and other regulations.
Areas where special caution is required
•
The insides of tanks, tubes, dome shafts, filling shafts, change over shafts, vessels
and dispensers.
•
All areas in which fuel vapour that is heavier than air can accumulate, e.g. fuel
separator, draining shafts, low located rooms, cellars, excavations, pipe trenches
etc.
•
The areas around the outlets of tank ventilation pipes, especially during the filling
phase.
•
All areas near dispensers, tanker lorries and other vehicles while they are being
tanked up, and particularly when there is a lack of wind.
•
A radius of 1.0 metres around petrol carrying pipes, as well as pipes that are not
vapour free.
•
Silt traps.
