Document Ref 942583-001 Rev 8
Page 5-21
Quantium 510 Installation Manual
Installation
5.4.7
USING JACKING BOLTS TO LOWER A DISPENSER
PREPARE THE DISPENSER FOR LIFTING
1)
Use a 13mm spanner or socket to loosen and remove the two bolts on the centre
pallet section on both sides of the dispenser. Remove both sides of the centre
pallet.
2)
With the dispenser stable on the two end pallet sections, carefully position the
forklift truck to lift the dispenser under the driptray.
Strap the dispenser to the forklift.
POSITION THE DISPENSER ON THE ISLAND
3)
Lift the dispenser and use a 19mm spanner or socket to loosen and remove the
two bolts on the end pallet sections on both sides of the dispenser. Remove both
end pallet sections.
4)
Position the dispenser over the island and feed the cables up through the electrics
hole position in the driptray.
5)
Carefully position the dispenser so that the filter boxes are directly above the
fuel supply risers. Lower the dispenser onto the island.
Note: Do NOT remove the forklift at this point.
6)
Align the mounting holes in the dispenser driptray with the corresponding holes
in the ground.
7)
Using a ratchet and a 19mm socket to turn the 4 jacking screws and slightly lift
the dispenser of the island
8)
Follow the instructions in section 5.4.8 to secure the dispenser to the ground
using the two mounting holes at the opposite side to the forklift.
9)
With one side of the dispenser secured, remove the forklift.
10) Fully lower the dispenser onto the island using the jacking screws.
11) Follow the instructions in section 5.4.8 to locate the opposite two bolts into the
two remaining holes provided.
Dispenser placement is complete.
