The red LED will flash for 15 times when you just switch to Live mode (ON),
and then the camera work automatically and enters the Standby mode.
To prevent incorrect signals and unnecessary photos, we recommend
not using the camera at sunny points and check that no branches are
in the active area of the sensor.
Also check that the camera is set to the correct height in line with the
point to be observed. Where necessary, point the camera down for
optimum alignment
Note
：
Please do the horizontal
movement before the PIR.
vertical movement could not
detect correctly.
Please quicken your steps when
you do the test in a long distance
before PIR detection area.
The PIR detection distance would be shorter if the environment
temperature reaches or above 30 °
The screen would automatically turn off without any operation within
3
minutes in SETUP mode, press any button will make turn it on again.
10
°
For 1 meter height, Place the camera parallel to the ground.
For 2 meters height, Tilt the camera down five degrees to the ground.
EN
15
