Toastmaster G-24, Owner'S Operating & Installation Manual

Page: 8 / 43

SECTION 1 - DESCRIPTION
2. Cooking Area
The Toastmaster Model G-24 has a 26" (660 mm)
cooking deck (chamber) and comes with a 15" (381
mm) wide conveyor belt.
3. Controller
The Controller controls both the temperature and
conveyor belt speed (cook time) of the oven. Cook
temperature can be set from 300°F to 950°F (149°C
to 509°C) and cooktime can be set from 0.5
minutes to 19.9 minutes.
4. Infrared Heating Panels
Patented heating panels are positioned above and
below the conveyor belt of each oven deck (cham-
ber). When energized these panels emit infrared
long waves. These waves do not heat the air
through which they pass. Instead the waves are
absorbed by the outer surface of the product
transported through the oven on the conveyor belt.
Using this application food is placed on the
conveyor and the unique properties of the infrared
waves cause it to cook from the outside to the
center in traditional fashion.
5. Heat Zones
The heat zones refer to individual areas of heat
control within a cooking deck (chamber). The deck
contains two heat zones (upper and lower). Refer to
Figure 1-4.
6. Conveyor
The conveyor is used to convey the product
through the oven deck (chamber). The conveyor is
made up of a frame and a stainless steel wire belt
which can travel in either direction around the
frame. The conveyor can travel at infinitely variable
speeds and the speed is controlled by the
Controller. The speed of the conveyor determines
how long the product will be in the cooking chamber
which is the cooking time. The oven chamber is 18"
(457 mm) wide with a 15" (381 mm) wide conveyor
belt.
7. Accessories
Kit For Stacking Two G-24's
An accessory stacking bracket kit (P/N ACSBG24)
allows you to stack two G-24's one on top of the
other (See Installation Section). This bracket must
be used when stacking a G-24 or the warranty is
voided. Instructions for stacking the ovens are also
available in the stacking bracket kit.
Kit For Stacking a Single G-24 on Top of a
Toast-master CO-19 or a Blodgett CTB-1
An accessory stacking bracket kit (P/N
ACSBG24C019) allows you to a single G-24 on top
of a Toastmaster CO-19 convection oven or a
Blodgett CTB-1 convection oven (See Installation
Section). This bracket must be used when stacking
a G-24 or the warranty is voided. Instructions for
stacking the ovens are also available in the
stacking bracket kit.
Front Facing Controller Kit
Another accessory is a remote control kit which
allows you to remove the control panel from the unit
and place it in a separate box connected to the G-
24 by a control cord five feet long. All necessary
parts and instructions are available in the remote
control accessory kit.
Figure 1-4
4