Toa VP-2241, Instruction Manual

Page: 214 / 328

Chapter 8: INSTALLATION AND SETTING PROCEDURES (HARDWARE)
4. VP-2064, VP-2122, VP-2241 AND VP-2421 POWEr AmPlIfIErS
8-36
4.3. Installing the VP-200VX Power Amplifier Input Module in the VP Power Amplifiers
Step 1. remove the top panel.
refer to
p. 8-34 "4.1. removing the VP Power Amplifier's Top Panel" for removal procedures.
Step 2. using nippers, clip out 4 connecting sections and the plate over the VP-200VX mounting location on
the power amplifier's rear panel.
Notes
•
cH1 is not covered with a plate.
•
remove only the plate of the channel to be used.
CH3 CH1
CH4 CH2
[VP-2064 Rear]
Cut off with nippers.
Step 3. unscrew the VP-200VX's panel.
Step 4. mount the VP-200VX module.
Attach the VP-200VX 's panel to the mounting location and the VP-200VX unit to the back of the
mounting location, then secure them to the amplifier using the screws removed in
Step. 3 .
Notes
•
Perform installation for lower mounting locations (cH2 and cH4) first.
•
mount the VP-200VX with its circuit board components faced down.
VP-200VX
VP-200VX 's panel
Mounting screw
(Use the screw removed
from the VP-200VX)