70
OFF (default), 1, 2, 3, 4, 5
Setting Range
(D8) Compressor setting (input/output)
C O M P R E S S O R –
O F F
Use the compressor to prevent power amplifier overload or to produce more easily heard sound by averaging
the audio level. The number shows the compressor's effectiveness level, which can be set by rotating the
Parameter setting knob.
• 1 (Peak limiter)
Provides a peak limiter function that protects amplifiers and speakers against damage caused by an
excessive signal input.
This level is suited to speech applications.
• 2 (Peak limiter)
Provides a peak limiter function that protects amplifiers and speakers against damage caused by an
excessive signal input.
This level is suited to musical (vocals) applications.
• 3 (Sonic normalizer)
Equalizes the sound volume of reproduced BGM among CDs or pieces of music by boosting small sounds
and lowering big sounds, making the entire sound volume uniform.
This level is suited to BGM reproduction.
• 4 (Speech leveler)
Makes paging calls easier to hear by equalizing the difference in speech signal volume that may result from
individual differences in speaker voice volumes or variations in speaker-to-microphone distances.
Since the volume is extensively corrected, the feedback margin narrows, making it liable to occurrences of
feedback. Therefore, special care must be taken when installing microphones and speakers.
This level is suited to microphone speech applications.
• 5 (Speech leveler)
Makes paging calls easier to hear by equalizing the difference in speech signal volume that may result from
individual differences in speaker voice volumes or variations in speaker-to-microphone distances.
This level 5 is more effective than level 4 described above. Since the volume is extensively corrected, the
feedback margin narrows, making it liable to occurrences of feedback. Therefore, special care must be taken
when installing microphones and speakers.
This level is suited to microphone speech applications.
V O X S E N S I T I V I T Y
– 3 0
(D9) VOX (Voice Operated Exchange) setting
Set the input signal level necessary for enabling the VOX function.
–40, –35, –30 (default), –25, –20, –15, –10, –5 dB
Setting Range
(D10) Lowest output level setting (when the AN-001T is used and ANC operation is set to ACTIVE)
M I N I M U M
L E V E L
–
6
Set the lower limit of the ANC-activated output level.
–18, –15, –12, –9, –6 (default), –3 dB
Note:
Settable level is 3 dB or more below the upper limit (highest output level).
Setting Range
Summary of Contents for A-9060DH
Page 136: ...200610 CU ...
