Rudder Feedback Installation Diagram
Rudder Feedback Installation Notes
•
When the rudder is central and the rudder feedback is central all angles
should be 90 ˚.
•
Use the snap swivel and ball joint on the rudder feedback arm
•
Use the rudder feedback adjustment block on the tiller arm
•
Hydraulic ram may be mounted on the other side of the tiller arm
•
Ensure that when rudder turns to Port, Rudder Feedback turns to Port
as indicated on the rudder feedback unit.
•
Rudder feedback unit may be mounted upside down. This would
require an electrical change. (Polarity of rudder feedback requires
reversing)
TMQ AP46 Autopilot
Page 26 of 34
Ver1.0 07/03/2007
