Wireless NVR Kit Manual
29
4.5.2 PTZ control operation
Steps
：
1, In the main interface, double-click the preview interface which need to be set
2, Right-click in the preview interface and select PTZ control in the shortcut menu, as shown in the following
figure
Operation explanation
：
：
Control the PTZ upward movement.
：
Control the PTZ downward movement.
：
Control the PTZ move to the left.
：
Control the PTZ move to the right.
：
Control PTZ automatic circular motion
+
：
Adjust the zoom +, focal , ap.
-
：
Adjust the magnification -, the focal length -, the aperture -.
4.5.3 PTZ automatic cruise setup
Steps
：
1, Right click in the main interface, in the shortcut menu, select the system setup, and then select the PTZ
setup in the channel setup.
2, Click on the right side of the preset "?" button to enter the control interface, set the preset point.
3, Select the preset position and set the direction.
4, Right-click to return to the setup interface, set to hold time.
5, Click the New button to complete a preset point of the setup.
6, Repeat the above steps 2-5 by setting the other preset points.
7, After setup, check the cruise and start checking box and change the pan / tilt speed as needed. As
shown below:
