172-65720MA-00 (FJ32-X+BD2) 22 Dec 2021
11
Disassembly/Reassembly
Use the following procedures to remove components. Use the same procedures in
reverse to reassemble. (Installation, inspection, maintenance, repairs, disassembly,
adjustment and valve opening/closing should be carried out only by trained
maintenance personnel.)
Detaching/Reattaching the Trap Unit and Connector Body
Part
During Disassembly
During Reassembly
Connector
Bolts 23
Remove with a socket wrench
Consult the table of tightening torques and
tighten to the proper torque
Trap Unit 1
Remove the trap unit
Follow the special instructions below
(see fig. A)
Connector
Gaskets 18,
19
Remove with a scraper without
scratching the seating surface
of the trap body.
Make sure there are no pieces of the old gasket
left on the sealing surfaces of the body and then
reattach; Be careful not to drop the new gasket
Attaching the Trap Unit to the Connector Body (Figure A)
1. If attaching a new trap unit, be sure to remove the
protective cap from the connector flange. Be careful not to
drop the gaskets when removing the cap.
2. Grasp the end of the trap unit and align its gasket housing
with the indentation on the connector body.
3. Once aligned, insert and finger tighten the connector bolts.
Verify that the trap unit is within the allowable inclination.
Figure A
Detaching/Reattaching the Cover
Part
During Disassembly
During Reassembly
Cover Bolt 15 Remove with a socket wrench
Consult the table of tightening torques and
tighten to the proper torque
Cover 2
Remove by lifting up and off
Make sure there are no pieces of the old
gasket on the sealing surfaces, align the cover
with the body and connector and reattach
Connector 16 Remove the connector
Reinsert it into hole in body
Cover Gasket
8
Remove the gasket and clean
sealing surfaces
Replace with a new gasket
Disassembly/Reassembly of Components Inside the Cover
Part
During Disassembly
During Reassembly
Figure B
Spring Clip 11 Pinch the insides together and
remove from the X-element guide
Insert securely into the groove
in the guide
X-element 14 Remove from the
X-element guide
Insert and ensure correct
orientation (Figure B)
Air Vent Valve
Seat 13
Remove with a socket wrench
Consult the table of tightening
torques and tighten to the
proper torque
X-element
Guide 12
Remove without bending
Insert the X-element gently
NEVER apply direct heat to the float.
The float may explode due to increased internal pressure, causing accidents leading to
serious injury or damage to property and equipment.
When disassembling or removing the product, wait until the internal pressure
equals atmospheric pressure and the surface of the product has cooled to
room temperature.
Disassembling or removing the product when it is hot or under pressure may lead to
discharge of fluids, causing burns, other injuries or damage.
WARNING
CAUTION
