Datalogic Gryphon
™
GM4100 / GD4100 Series – Programming Guide
Datalogic Gryphon
™
GM4100 / GD4100 Series: Programming Guide – March 29, 2012
1
GM4100 Syncing
When using the
Gryphon
™
GM4100
(wireless) series scanner, after scanning any barcode in this
document (except when advised to scan both barcodes before syncing), and before proceeding
with the scanning task, return the scanner to its base to allow the base to sync with the scanner.
During the sync process lights will flash on the scanner base. When the lights stop flashing the
sync is complete. The sync process typically completes in 10-15 seconds.
Before You Begin
Important!
If the GM4100 (wireless) was previously linked to another base you must
first
scan
the
Unlink
barcode at the end of page 2.
Whether or not you needed to scan the
Unlink
barcode, before you begin using either model
scanner you must first scan the
Interface
USB Keyboard EM
barcode below.
USB Keyboard Emulator
Note
: If using the GM4100 (wireless) unit, scan the
Interface
USB Keyboard Em.
barcode
below and return the unit to the base to sync.
After the sync is complete scan the appropiate function barcode on the following pages, taking
note of the barcode’s accompanying instructions.
³
$ P
,
H A 3
5
,
P
Interface USB Keyboard Em.
Disable Carriage Return
By default,
Carriage Return
<CR> is enabled. This function should remain enabled if using
the scanner for circulation purposes. To use the scanner with
L.S Cataloging
, you may wish
to disable
Carriage Return
.
Note
: If using the GM4100 (wireless) unit, scan the appropriate barcode before returning the
scanner to the base to sync.
³
$ P
, C L F S U 0 0 0 0
, P
Suffix = none
.
Enable Carriage Return
³
$ P
, C L F S U 0 D 0 0
,
P
Suffix of CR
