2.4 Installation
Read the safety and installation sections of all system component manuals before installing your equipment.
A thorough understanding of system components and their requirements will help you install the system
safely and efficiently. Failure to follow these safety procedures can result in personal injury or death.
•
Allow only qualified personnel to install TKH Airport Solutions and auxiliary equipment. Use only approved
equipment. Using unapproved equipment in an approved system may void agency approvals and will void
the warranty.
•
Make sure all equipment is rated and approved for the environment in which you are using it.
•
Follow all instructions for installing components and accessories.
•
Do not hold / carry the light assemblies by the cables.
•
Install all electrical connections to local codes provided they are not in contradiction with the general
rules.
•
Use only electrical wire of sufficient gauge and insulation to handle the rated current and voltage demand.
All wiring must meet local codes.
•
Route electrical wiring along a protected path. Make sure the wires will not be damaged by moving
equipment and animals (e.g. rodents).
•
Protect components from damage, wear, and harsh environmental conditions.
•
Allow sufficient room for maintenance, panel accessibility (power products), and cover removal (power
products).
•
Protect equipment with safety devices as specified by applicable safety regulations.
•
If safety devices must be removed for installation, install them immediately after the work is completed
and check them for proper functioning.
2.5 Operation
Only qualified personnel (see Qualified Personnel on page 6) should operate this equipment. Read
all system component manuals before operating this equipment. A thorough understanding of system
components and their operation will help you operate the system safely and efficiently.
•
Before starting this equipment, check all safety interlocks, fire-detection systems, and protective devices
such as panels and covers. Make sure all devices are fully functional. Do not operate the system if these
devices are not working properly. Do not deactivate or bypass automatic safety interlocks or locked-out
electrical disconnects or pneumatic valves.
•
Never operate equipment with a known malfunction.
•
Do not attempt to operate or service electrical equipment if standing water is present.
•
Use this equipment only in the environments for which it is rated. Do not operate this equipment in humid,
flammable, or explosive environments unless it has been rated for safe operation in these environments.
•
Never touch exposed electrical connections on equipment while the power is ON.
•
Never look directly in the light source while the power is ON.
Installation and Maintenance Instructions - LED AGL Runway Guard Lights - type 921
©
TKH Airport Solutions 2022. All rights reserved.
7
