21
Phone: +49 (0)5 41/58 22-0 Fax: +49 (0)5 41/58 22-491 email: [email protected]
L
Tb1547GB(1113)1
TIOS
®
EL18
Battery-operated Lockbolt Tool
Operating instructions
Troubleshooting
Caution
Important
Note
Work that may be performed by the operator is highlighted by the letter
“O”
.
Work that may be performed by the trained personnel is highlighted by the letter
“T”
.
Risk of accident!
Remove the battery at all times until the fault has been detected.
Damage to materials! Work that is highlighted by the letter
“T”
may only be performed by
trained personnel. Submit the rivet tool to Maintenance.
Only trained personnel may replace original parts.
A full function test must be performed each time a fault is repaired.
Malfunctions
Rivet does not install
Mandrel is not rejected
Battery does not charge in charger
Cause
Flat battery (LED flashes orange)
Spent mandrel collector not correctly attached
(LED flashes green)
Loose jaw case or jaws are defective
Jaws / jaw case dirty
Slide pipe dirty
Mandrel too large for nose piece
Mandrel wedged inside jaws
Defective battery (right LED flashes red)
Defective charger (left LED flashes red)
Charger not connected to mains
(left LED dead)
Remedies
O
Replace battery
O
Attach collector
O
Replace jaws + jaw case if necessary
O
Clean
O
Clean
O
Replace nose piece
O
Loosen nose piece, remove lock nut
and cap. Loosen jaw case, replace jaws if necessary
T
Replace battery and dispose of used one properly
T
Replace charger and dispose of used one properly
T
Check the power supply on the charger
Description
Lock nut
Jaw case body
Pulling head housing
Pos.
2
4
Z
Thread
M 40
M 16
17 / 32 inch
Torque MA in Nm
Hand-tight
30 Nm
30 Nm
Table for starting torques
The table below shows the torque values that must be adhered to for the specified threads.
