TIPTEL 106 VoIP, Installation Instructions Manual

Page: 32 / 36

Appendix
14
Appendix
Overview of telephone programming codes
If you can no longer access your tiptel 106 VoIP via the network, the data relating to
the network can also be entered via the telephone. Please note that the complete
menu guidance takes place in English.
•
Insert the supplied RJ11-RJ11 cable into the "PHONE" socket (see above)
and in an analog telephone set to tone dialing (DTMF). Check which sockets
the telephone uses! To meet international standards "a/b" must be in the
middle on contacts 3 and 4. Older Deutsche Telekom and Siemens
telephones may use other sockets. If this is the case use an adapter cable
(not supplied).
•
Ensure that the "LINE" socket is not used! If necessary remove the cable that
is plugged in there.
•
Lift the receiver of the analog telephone, you will hear an interrupted dial
tone. Immediately dial

in quick succession.
•
You are in the settings menu. Then enter the programming code and any
input data stated in the table below.
Data Progr. code Input data Notes
Check DHCP
status 100# none Message as to whether DHCP
is activated or not
Set DHCP
status 101# 1# to switch on
0# to switch off Then
1 to save
2 to check
3 to reenter
* to cancel
Check IP
address 110# none IP address is read out loud
Enter IP
address 111# nnn*nnn*nnn*nnn# Numbers are read out loud for
checking, DHCP must be
switched off
Check
network mask 120# none Network mask is read out loud
Enter network
mask 121# nnn*nnn*nnn*nnn# Numbers are read out for
checking, DHCP must be
switched off
Check
gateway 130# none Gateway address is read out
Enter gateway 131# nnn*nnn*nnn*nnn# Numbers are read for
checking, DHCP must be
switched off
Reset to
factory default 73738 1* to accept reset Device is reset to factory
default