Hand Control Programming-TDH3
Version 3 August 2021
8 of 10
8
6.
Presetting the Desk Starting Height
(1)
Press
-
button until the desk reaches its lowest position and then release
-
button. Re-press
-
button
again for 5 seconds and the digital display will flash for 10 seconds.
(2)
Adjust the starting height number with the
+
or
-
button.
(3)
After 10 seconds, the display will stop flashing and this will confirm that you have successfully set the
starting height.
7.
Restore Factory Setting
(1)
Refer to Chapter 2-Reset: after the “beep” sound, press + and - buttons together for 15 seconds, the
control box will twice make a “beep” sound, and the digital display will show “---. “
(2)
The settings below will restore to the original factory settings:
Memorized position
Desk starting height
Upper and lower height limit
T-touch or TCS1 sensitivity
