Timewave DSP-D300, Manual

Page: 48 / 112

Raw bytes to Local Port (COM1)
Send the raw data bytes directly to the
Local port, bypassing any packet
testing.
Raw bytes to Satellite Port (COM2)
Send the raw data bytes directly to the
Satellite port, bypassing any packet
testing.
Raw bytes to Ethernet Port (COM3)
Send the raw data bytes directly to the
Ethernet port, bypassing any packet
testing.
The PC’s Virtual CDC COM Port will always have raw bytes.
Logging
The Control300 program can log the packet directly from the demodulator. This
may be used for comparison with port output doing diagnostics. Also the text
shown on the Control300 monitor may be logged. Choose
Tools/Options/Logging…
to setup the log.
Figure 13: Control300 Log setup
To Log the monitor data, set the Terminal filename and then make sure that
“Terminal” is checked.
To Log the IFLOWS data, set the IFLOWS filename and then make sure that
“IFLOWS” is checked.
For the log format, see
Log Format
in the
CommReadTW Diagnostic Program
section.
Log Format
The log generated is in the following log format:
48