Figure 6-8 Set RS-485 Parameters
3. Select an peripheral type according to your actual needs.
Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
4. Tap the back icon at the upper left corner and you should reboot the device if you change the
parameters.
6.6 User Management
On the user management interface, you can add, edit, delete and search the user.
6.6.1 Add Face Picture
Add user's face picture to the device. And the user can use the face picture to authenticate.
Steps
Note
Up to 300 face pictures can be added.
1. Long tap on the initial page for 3 s and slide to the left/right by following the gesture and log in
the backend.
2. Tap User → + to enter the Add User page.
3. Edit the employee ID.
Note
• The employee ID should be less than 32 characters. And it can be a combination of lower
letters, upper letters, and numbers.
• The employee ID should not be duplicated.
4. Tap the Name field and input the user name on the soft keyboard.
20
ULtraFace 331 Face Recognition Terminal User Manual
Page 27 of 68
