Timespace X300 Mark 2, Instruction Manual

Page: 32 / 185

X300 Instruction Manual Chapter 3 - User Guide – X300 Menu System
21
3.1.3.5 Alarm Output/LEDs
This menu sets the conditions for the Alarm outputs. This determines whether the X300 alarm output
goes closed or open when any of the set conditions are met. The X300 has three outputs; LED1 (LD1),
LED2 (LD2) and ALARM OUT (ALM).
ALARM OUTPUT CLOSED/OPEN WHEN…
TEST OPEN/CLOSED - Sets the input to OPEN/CLOSED for testing purposes.
ALARM OCCURRED - An ALARM event has occurred.
RECORD LED - The front panel record LED is active.
DISK LED - The front panel disk LED is active
SD RECORDING - SD recording is occurring
FAIL LED - The front panel fail LED is active
SERVICE LED - The front panel service LED is active
FRONT LEDS - Any of the front panel LEDs are active
CAM DISCONNECTED - Any camera is disconnected
GSENSOR TRIGGER - Any of the XP200 GSensor configured thresholds are reached / exceeded.
LAN ACTIVE - Files are being transferred via the LAN interface
HD WP % -
A percentage of the hard disk cartridge contains Write Protected files:
25, 50, 60, 70, 80, 90 and 99%.
HD FULL %
-
A percentage of the hard disk cartridge if full; 25, 50, 60, 70, 80, 90 and
99%.