Times Fitness Sensors, User Manual

Page: 60 / 151

3. The timer will stop after the alert if set to STOP.
OR
The timer will begin another countdown if set to REPEAT and
continue until you press
STOP/RESET .
The lower line of the display will show RPT and a number (for
example, RPT 2). RPT indicates the timer is repeating and the
number indicates how many times the timer has cycled
through the repeat countdown. You will also see the
repeat icon, indicating the timer is set to repeat.
OR
The timer will switch to Chronograph, Finish, or Vertical
Mode if set to one of these modes. You will
see the switch mode icon, indicating the
timer will switch modes at the end of the
countdown.
NOTE : The timer will only switch to the Chronograph, Finish, or
Vertical Mode if you reset the chronograph to zero and
Sync Timer & Chrono is turned off (see “Hand-free
settings” on page 63).
When you set the timer to switch modes at the end of the
countdown, the information recorded while in Timer
Mode will not carry over to the next mode and will not
show up in Summary Mode.
53
You can press MODE from Timer Mode to switch the display to
another mode without disrupting the operation of the timer.
The timer icon will appear indicating timer operation.
NOTE : The Timer includes settings for two intervals. However, if
you set either interval to zero, it will operate using only
one interval.
TO SET TIMER MODE
For instructions on setting Watch functions, including Timer
Mode, refer to page 13, “To set Watch functions.”
For Timer Mode, you can set the following values:
v
Time (hours, minutes, seconds for up to 99 hours, 59 minutes,
and 59 seconds).
v
End action (STOP, REPEAT, or CHRONO, VERTI, or FINISH).
TO OPERATE THE TIMER IN TIMER MODE
1. Press START/SPLIT to start the Timer countdown.
Pause the countdown by pressing STOP/RESET , resume the
countdown by pressing START/SPLIT again, or reset the
timer, by pressing and holding STOP/RESET .
2. When the timer reaches zero for each interval, a brief alert
sounds.
52