ECC 294
Page 1
73J008 REV A
PROM Installation Guide
Micro Lynx System Unit (SU)
q
Optional
TIMELINE VISTA, INC.
1755 LA COSTA MEADOWS DRIVE, SUITE B
q
Recommended
SAN MARCOS, CA 92069
TEL. 760-761-4440
q
3
Mandatory
(FAX 760-761-4449)
System Unit PROM Installation
DATE:
06/12/92
MODEL:
Micro Lynx
REVISION:
All
SERIAL NO:
All
SOFTWARE:
Machine Control PROM
U51
U47
Control PROM
U4
DESCRIPTION:
There are three PROMs in the System Unit. A software upgrade may require replacement of either the
machine or control PROMs. Replace only the PROMs that were shipped to you.
Look at the PROM(s) in the shipping container. The Software Version number is listed on the PROM
label; the number is preceded by MC or CP. Micro Lynx uses two MC (Machine Control) and one CP
(Control Processor) PROM. Both MC PROMs must be replaced at the same time,
do not replace only one
!
Record the serial numbers and software version in the front of your Micro Lynx Manual, they are
required to receive assistance from Customer Service.
REQUIRED TOOLS:
Static safe workstation
Grounding wrist strap
IC Extractor/Insertor
Phillips screwdriver
or small screwdriver
PROCEDURE:
1. Turn off the power and disconnect all
power cables.
2. Place the Micro Lynx System Unit on a
static safe workstation. Ground yourself and the workstation anti-static mat.
3. Remove the six phillips screws securing
the top cover to the chassis. Turn the
System Unit so that the front panel faces you and remove the top cover.
