Quick-Start Instructions
Round Pattern 24 Hour Electro-mechanical
Time Controllers with Half Day & Day Omit
RTS113/RTS114
7 day control (blue) (C)
Segments with screwdriver
slots pointing around outer
(7 day) programme ring (B)
Permanent ON override
indicator (A)
Permanent ON override
push button (A)
Blue tappet OFF (D)
Figure 1
Figure 2
Time/day marker (D)
24 Hour programme ring (D)
Red tappet ON (D)
Carry out A to D in sequence referring to figs 1, 2 and 3:-
A
Permanent ON override indicator must point to AUTO, if not press Permanent ON override
push button firmly.
B
All the segments on the outer (7 day) programme ring must have their screwdriver slots
pointing around the ring. Any that are not must be turned in a clockwise direction with a small
screwdriver until they are (fig. 3 shows one segment set as required and one incorrectly).
C
The 7 day (blue) control must have its screwdriver slot lined up with either bar (
I
for ON), if not
use a small screwdriver to turn the control in a clockwise direction until they line up (see fig. 2).
D
Position red (for ON) and blue (for OFF) tappets as required around the 24 hour programme
ring (one ON at 21-30 and one OFF at 6-00 shown as an example). Rotate the 24 hour
programme ring clockwise through one complete turn and then further till the current time of
day is lined up with the time/day marker. (12-00 midday is shown as an example). The correct
position of the 24 hour (red) control has been set automatically by the above procedure.
Wire up (see main instructions) and apply power to the timeswitch. It is now operational.
Bar
Screwdriver slot on
7 day (blue) control
lined up with a bar
Figure 3
Set Up for 24 Hour Operation
Set as
required
Incorrectly
set
✓ ✗
