Timberk T-PAC12-P11E, Instruction Manual

Page: 40 / 64

IM2021
40
13. UTILIZATION RULES
After the lifetime of the device expires, it should be recycled in compliance with the
laws, rules and methods in region of recycling. Detailed information about the recycling
of the device, you can receive from a representative of the local authorities, after
providing full information about the device. The manufacturer and authorized
organization of the manufacturer do not carry responsibility for the fulfillment by the
Buyer of the requirements of legislation on utilization and methods of utilization of the
device selected by the Buyer. The lifetime of the device is indicated in the warranty
card. Warranty period for the device and warranty terms are specified in the warranty
card. The warranty card is an integral part of the documentation supplied with this unit.
If there is no warranty card in the delivery set, ask for it from the Seller. The warranty
card provided by the Seller must conform to the manufacturer’s form.
The manufacturer and the authorized organization of the manufacturer remove
responsibility for any possible harm which can be caused to people, animals or
property directly or indirectly, if this harm occurred as a result of noncompliance with
The cooling
effect is not
good Doors or windows are open;
there are a lot of people; or in
cooling mode, there are other
sources of heat.
Close doors and windows, and add
new air conditioning.
The filter screen is dirty. Clean or replace the filter screen.
The air inlet or outlet is
blocked.
Clear obstructions.
Big Noise
The air conditioning is not
placed on a flat surface. Put the air conditioning on a flat and
hard place (to reduce noise).
compressor
does not
work.
Overheat protection starts.
Wait for 3 minutes until the
temperature is lowered, and then
restart the machine.
The remote
control does
not work.
The distance between the
machine and the remote
control is too far.
Let the remote control get close to
the air conditioning, and make sure
that the remote control directly faces
to the direction of the remote control
receiver.
The remote control is not
aligned with the direction of the
remote control receiver.
Batteries are dead.
Replace batteries.
Displays 'E1'
The room temperature
indicator is abnormal.
Check the room temperature
indicator. Disconnection of contact
assemblies is possible.
Displays 'E2'
The pipe room temperature is
abnormal.
Check the pipe temperature sensor.
Possible failure, replacement is
required.