18
8.2.2. Daily programmer
NOTE: Make sure that the starting up and shutting down time does not overlap. It isalso
necessary to pay attention that between this two processes pass at least 30 minutes.
During the daily programming you can set two starting ups and two shutting downs of the system.
Press the key 3 (set), afterwards there will be displayed
menu 01 SET CLOCK
. Then press the
key 5 twice to get the message
menu 02 SET CHRONO
. Pressing the key 3 (set) you access the
timer setting menu, and consequently in the menu foe turning the timer on. On display will show
m-
2-1 ENABLE CHRONO
. Then again presses the key 5 and the on display will show up the
message
m-2-2 PROGRAM DAY.
Afterward, pressed the key 3 (set) and there will be displayed
off m-2-2-01 CHRONO DAY
. With
the keys 1 and 2 switch the on command, in order to activate a daily timer. Use the keys 5 and 6 to
scroll through menus, and the keys 1 and 2 to change the parameters. The menu is shown in the
following table. Time can be set in intervals of 10 minutes.
To exit the timer setting press the key 4 twice.
SETTING EXAMPLE:
The stove is starting up at 6 am and turning off at 8 am, the next starting is
at 2 pm and turning off in 10:30 pm. Parameters need to be set according to a following table.
m-3-2-01 CHRONO DAY
on
m-3-2-02 START 1 DAY
06:00
m-3-2-03 STOP 1 DAY
08:00
m-3-2-04 START 2 DAY
14:00
m-3-2-05 STOP 2 DAY
22:30
x 2
Summary of Contents for rittium 14 hydro
