3
TigerStop Controls
The mitering motion and the pushing motion on a TigerSaw Miter have very similar control electronics (above).
Throughout this manual, these components will be referred to as (from left to right):
•
Amplifier
•
I/O Panel
•
Controller
The amplifier, on the left, provides power to drive the motor.
The controller, on the right, allows the operator to control the machine.
The I/O panel, center, provides ports to support additional components.
•
The mitering motion does not require an I/O panel. The mitering controller is connected directly to the amplifier.
Controller cables connect the amplifier to the I/O panel and controller.
•
The direction of the controller cables, indicated by the color of the plugs, is important.
•
If a cable has blue and yellow plugs, the yellow plug is equivalent to the pictured black plug.
The tablet package (below) controls both pushing and mitering motions.
Summary of Contents for TigerSaw Miter
