21
1. At the Menu Select screen, press
twice
2. Press the [Debug] soft key to access the Debug menu.
3. Press
to scroll through the settings. Stop when you get to the
Debug Mode setting.
4. Press [C].
5. TigerRack will ask for a password. Enter the number 81980 and press [=].
6. Press [C] to turn Debug Mode ON.
7. Press
.
8. Press
twice.
9. Press the [SysInfo] soft key to access the System Information menu.
10. Press
to scroll through the settings. Stop when you get to the
Brake setting.
The Brake setting has two options;
Pusher
- The brakes will engage after the tool has started its cycle.
Note: Pusher brake mode is only available when using a standard or advanced interconnect kit.
Setpoint
- The brakes will engage as soon as TigerRack has stopped moving.
To change Brake...
1. Press [B] or [C] to toggle the brake setting.
2. Press the [Done] soft key to save the parameter.
Set Optimizer Settings
TigerStops Dynamic Optimizer is tuned from the factory to give the best overall material yield.
However, the optimizer can be configured differently if you have different requirements.
1. From the Ready Screen, press the [Show] soft key to show the menu
options.
