Destroyer droids are elite units of the Trade Federation’s army.
These highly engineered “soldiers” excel in a variety of combat
situations. Also called “wheel droids”, they are rapidly moving
armored wheels that unfold into powerful, three-legged weapon
platforms. Now you can unleash the power of a destroyer droid to
protect your room and valuables from unwanted intruders! Destroyer
droids stand sentry in their “closed wheel” position guarding against
unwanted intruders. When an intruder is detected, the destroyer
droids spring open to the “attack” position and the alarm is sounded!
1. GETTING STARTED
3. SET UP
2. BATTERY INSTALLATION
CAUTION: Battery installation and replacement should be done by
an adult. This product is not suitable for children under 3 years old
as it contains small parts.
To reset into the “closed” position, you must slowly and gently move
the Room Alarm as follows:
The Room Alarm must be
manually reset in the “closed”
position (see diagrams above)
each time the alarm is activated.
If the Room Alarm is in the “attack”
position and an intruder is detected,
it will sound the alarm but it will
not move. Resetting the Room
Alarm into the “closed” position
before an intruder is detected will
allow the Room Alarm to sound the
alarm and open to the "attack"
position when an intruder is
detected.
The Room Alarm is in the “attack”
position when it is fully opened with
its head up, limbs outward and
weapons out.
On/Off
Switch
Red Alarm
Active
Indicator
Light
Heat (PIR) Sensor Lens
3 Alarm
Sound
Effect
Selection
Buttons
TO ENSURE PROPER FUNCTION :
– DO NOT MIX OLD AND NEW BATTERIES.
– DO NOT MIX ALKALINE, STANDARD (CARBON ZINC) OR RECHARGEABLE
BATTERIES.
– BATTERY INSTALLATION SHOULD BE DONE BY AN ADULT.
– NON-RECHARGEABLE BATTERIES
ARE NOT TO BE RECHARGED.
– RECHARGEABLE BATTERIES ARE TO BE REMOVED FROM THE TOY BEFORE
BEING CHARGED (IF REMOVABLE).
– RECHARGEABLE BATTERIES ARE ONLY TO BE CHARGED UNDER ADULT
SUPERVISION (IF REMOVABLE).
Carefully loosen the battery door
screw and open the battery
compartment door on the bottom
of the product. Insert 5 Alkaline
“AA” batteries, LR6 or equivalent,
making sure to align “+” and “—” as
shown. Close the battery
compartment door and tighten the
screw. Do not over-tighten as this
may cause damage.
– ONLY BATTERIES OF THE SAME OR EQUIVALENT TYPE AS RECOMMENDED
ARE TO BE USED.
– BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY.
– EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE TOY.
– THE SUPPLY TERMINALS ARE NOT TO BE SHORT-CIRCUITED.
1
. Pull the head downwards
as indicated.
“ATTACK”
Spot
Light
“CLOSED”
To attach the arms, slide each arm
into the arm holes as illustrated.
Snap the arm into the arm holes.
