40
Genie Distribution WNET Manual v3
© Tieline Research Pty. Ltd. 2020
10
Genie Distribution Headphone/Aux Output
The codec has a 6.35mm (1/4") RTS stereo
HEADPHONE
output for monitoring inputs and return
audio. If you are using analog inputs or digital inputs you will see audio metering on the PPMs and
can monitor it with the headphones.
Important Note:
The front panel
HEADPHONE
output and rear panel
HP/AUX
output
share the same hardware output. This means both are switched and configured together.
I.e. both outputs are either a stereo headphone output (default setting), or a balanced
mono auxiliary output.
Configure for Headphone and Aux Output
Both the front panel
HEADPHONE
and rear panel
HP/AUX
outputs are configured as stereo
headphone outputs by default. To adjust this setting:
1. Press the
SETTINGS
button.
2. Navigate to
Audio
and press
.
3. Select
HP/Aux Out
and press
to toggle between
Headphone
and
Aux Out
.
Adjust Headphone Output Settings
1. Press the
HEADPHONE
button to display the headphone monitoring adjustment screen.
2. Use the left
or right
navigation buttons to adjust the volume level up or down. The screen
displays level adjustments in real-time.
3. Press the down
navigation button to select the
Send/Return
audio balance and use the left
or right navigation buttons to adjust the balance. The
Send/Return
audio balance dictates
whether the front panel
HEADPHONE
output and the rear panel
HP/AUX
output monitors send
(input/encoder) audio only, return audio only (decoder audio from a connected device), or a mix
of both send and return audio.
4. Press
RETURN
when you have finished to exit the menu.
Note: Headphone levels can also be adjusted by pressing the
SETTINGS
button, navigate to
Audio
and then
HP Vol/Bal
and press
.
Adjusting the Monitor Source
In headphone listen mode it is possible to select monitoring sources via
HEADPHONE
>
Monitor Source > [Select audio Source]
.