166
Genie Distribution WNET Manual v3
© Tieline Research Pty. Ltd. 2020
8. Click the drop-down arrow for
Monitor Modem Tone
to select either
Enabled
or
Disabled
.
When enabled the module will allow audio monitoring of modem tones during connection in
POTS Codec
mode via the phone input. By default, the following phone input monitoring rules
apply when multiple POTS G5 modules are installed in a codec and multiple POTS
connections are dialed.
Module 1
Module 2
Audio Rule
POTS Codec
(Monitor Modem Tone)
POTS Codec
(Monitor Modem Tone)
The phone input receives a mix of modem tone
audio from both modules
POTS Codec
(Monitor Modem Tone)
Analog Phone
The phone input receives analog phone input
audio only and mutes modem tone monitoring
Analog Phone
Analog Phone
The phone input receives audio from the oldest
active connection only
Important Notes:
·
Modem tone monitoring will work even if
Phone Input Enable
is
Off
via
Settings >
Audio > Phone Input > Phone Input Enable [Off]
.
·
Modem tone monitoring is only enabled during the initial connection training and
negotiation period in
POTS Codec
mode.
·
The monitoring volume can be adjusted using the codec front panel via
Settings >
Audio > Phone Input > Level
,
or by opening the
Inputs panel
in the Web-GUI and
adjusting the
Phone
input volume slider.
9.
Country
displays the current country setting in the codec. To adjust this setting select
Settings
> System > Country
.
10. Click
Save
when configuration is complete.
20.9.2
Configuring POTS Answering
It is possible to store a different
POTS Answer Config
for each POTS module installed in the
codec. POTS answering can be configured to suit:
·
The type of call being made, e.g. Tieline (with Tieline Session Data) versus non-Tieline
(Sessionless).
·
Expected dialing behaviors and encoding, e.g. whether audio streams use
Route
tags and
which algorithm is used.
If you answer a call from a non-Tieline codec you will need to create an answering "Config" to
determine which module in the codec will answer the call and the settings used when connecting.
Important Notes:
·
POTS Answer Config
settings are applied to
POTS Codec
connections and not
Analog Phone
connections.
·
When receiving a call from a Tieline codec with session data enabled (i.e. not
Sessionless
), the algorithm setting from the dialing codec overrides the setting in the
POTS Answer Config
menu.