TIE DOWN PENETRATOR Assembly Instructions Download Page 1

Penetrator and Roof Zone Cart

Assembly Instructions

Important – Please Read These Instructions Fully Before Starting Assembly

Step 1

Pull from this side

Position the Cart and Penetrator as close as possible

to the final assembly. Stand up the Penetrator on its

extension arm and safety plate.

Step 2

Pull the Penetrator device under the cart from the

opposite side of the cart. Stop pulling when the

pull pin stop is aligned with the cart.

Step 3

From the weight side of the Penetrator, lift up on

the pull pin mounting bracket. Align the holes with

the Penetrator and the pull cart. Insert the pull pin

through the bracket and cart. Attach safety pin

to the pull pin.

When you open the Penetrator Fall Protection

device for the first time, some minor assembly

will be required.  The Penetrator device is shipped

as shown to the right. The front guard plate, cleats and

cart assembly must be assembled before use.

Instruction Sheet #08264   (E1449 Rev. 3-7-2016)

030716,E1449

Reviews: